Digital Gear indicator

[1934sedan]

Hello guys can you tell me what is required to install one of these gauges?  How do you install them?


Thanks

[justfreaky]

You will need the 6 wire indicator plate and the digital indicator. I believe you can buy it as a kit from USLC. They are not real cheap. The indicator plate is about $80. You can find a used one once in awhile. You might advertise that you are looking for one. Perhaps someone has one laying around.

Steve

[VMS Motorsports]

Your engine may have the plate on it already, so you may only need the gauge

[racintaz99]

I know the enite kit is around $250 as I had checked into this at the begining of the 2012 season. I just have not had the extra money due to other engine problems that needed to be fixed.


I have been looking for a used one too but I am not having too much luck with that. If you find someone that has more than 1 used, let me know as I am still interested in getting one for this season.

Scott

[1934sedan]

Ok great guys how do you wire it in?

[Legends57x]

Very simple...Supply fused 12 VDC supply via red wire and then it's just a matter of plugging 6 wire connector plug from gauge to 6-wire shift sending unit.  Make sure to install good O-ring  with light coat of oil on sending unit and just snug hand tight sending unit fasteners.

Good luck! 

[1934sedan]

Thank you!!

[phylzub02]

I AM INTERESTED IN A USED GEAR INDICATOR AND THE ASSY FOR THE MOTOR IF ANYONE HAS ONE THEY WANT TO GET RID OF..FRANK @1-208-353-2283

[justfreaky]

I have a digram to build the light part of the indicator; You would still need to get the 6 pin indicator plate.

Steve

[Racingtrader.ca]

I AM INTERESTED IN A USED GEAR INDICATOR AND THE ASSY FOR THE MOTOR IF ANYONE HAS ONE THEY WANT TO GET RID OF..FRANK @1-208-353-2283

I have a brand new one still in the box for 200.00

[Vern Houseman]

is it a complete kit ?

[Racingtrader.ca]

Yes it is everything you need, Its still in the packaging from USLC. Its brand new.