Reply to question 1, found in your 2010 rule book or on-line:
28. SCOOPS/DUCTWORK: A maximum of two scoops are permitted on any Bandolero Car. Only one scoop is permitted per side of the car. The scoops must be mounted approximately 14” forward from the center of the rear wheels. The scoops must measure approximately 8 1/2” up from the bottom edge of the body to the top of the scoop. A hose is permitted to be attached to the scoop to assist in the directing of airflow to the brakes or the engine. The hose must be firmly attached to the end of the duct and must be mounted securely, directing air to the brake caliper or the engine only. The permitted hose may not measure any larger than 3” in diameter. Fans may not be placed inside the hose or duct. Any competitor caught directing air to any other location other than the brakes or the engine will be disqualified. The scoops may be no larger than the scoop offered by U.S. Legend Cars International. Competitors may not direct air to the air filter box or the carburetor in any way.
Reply to question #2, found in the 2010 rule book or on-line:
3. CLUTCH GEAR: The only clutch gear permitted is the 12, 13, 14 or 15 tooth as delivered by U.S. Legend Cars International. The only clutch springs allowed are the ones as delivered by U.S. Legend Cars International. The clutch otherwise must remain in its stock configuration as currently sold by U.S. Legend Cars International. No other modifications are permitted to the clutch (i.e.- use of a non-slip clutch, welding of the clutch). The clutch shoes must remain unaltered with the exception of regular maintenance by sanding the shoe face. The shoe must not be thinner than .180” to be measured at either end of the shoe (both ends must be .180” or more).
Nothing found in the rule book pertaining to Oil coolers, except the catch-all:
If this rulebook does not specifically say that you can change/modify/add something, then you must consider that the change/modification/addition is illegal. Any questions about the legality of a change/modification/addition not covered in this rulebook, must be answered by INEX in writing and presented to the tech inspector upon request. If you have a request for a change/modification/addition, please contact INEX before making the change/modification/addition.