Author Topic: Bando Wiring Diagram  (Read 1628 times)

Offline Bentracin

  • Newbie
  • *
  • Posts: 10
Bando Wiring Diagram
« on: December 05, 2014, 11:59:22 pm »



Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4289
Re: Bando Wiring Diagram
« Reply #1 on: December 06, 2014, 12:17:52 am »
Our good friend Ed has some very good info on his site. Most of it is shared here on this site as well.
There is good info on buying and maintaining a bando car. I finally got around to buying his Bando book this year.

Steve
Better to be hated for who you are, Than to be loved for who you are not.

Offline djratliff

  • Newbie
  • *
  • Posts: 2
Re: Bando Wiring Diagram
« Reply #2 on: May 19, 2019, 02:38:01 pm »
Hello Everyone,

This link seems to be dead.  Does anyone have this diagram?

Thank you,

Dave


Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4289
Re: Bando Wiring Diagram
« Reply #3 on: May 19, 2019, 07:49:22 pm »
Not sure what happened with  Bandostuff.com. I was able to access it a few months back. I'll have to see if I can remember how I did it.
Better to be hated for who you are, Than to be loved for who you are not.

Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4289
Re: Bando Wiring Diagram
« Reply #4 on: May 20, 2019, 09:25:50 am »
Hopful that this will help you

Better to be hated for who you are, Than to be loved for who you are not.

Offline djratliff

  • Newbie
  • *
  • Posts: 2
Re: Bando Wiring Diagram
« Reply #5 on: May 27, 2019, 03:26:19 pm »
 Thank you.

One question, where does the kill switch wire off the engine go? 

Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4289
Re: Bando Wiring Diagram
« Reply #6 on: May 27, 2019, 08:17:03 pm »
I really do not know. I assume to ground.
Better to be hated for who you are, Than to be loved for who you are not.


Offline Legends57x

  • Sr. Member
  • ****
  • Posts: 408
Re: Bando Wiring Diagram
« Reply #7 on: May 28, 2019, 10:47:19 am »
DJ,

All small air cooled engines have a grounding tab of some sort attached to the ignition coil(s) which serves as the kill point to shut down the engine. It is normally a black colored wire that will need to be attached to the kill switch on your car. Other side of the kill switch should go to a chassis ground. Think of the kill switch box in the provided diagram as the ignition coil on the engine.

Hope this helps!
Mark Ritger
INEX Legends #1x