Help!,,,
A couple of questions and looking for advice. I have a Caster/Camber tool and using it on a Legends car.
When setting Camber/Caster should the car have the driver or weighted when setting?
Are the final settings measured /checked with the car/wheel on the ground?
Should it be checked with the car on stands? with weight off the wheel , without wheel?
I am looking for the right procedure for setting these, as the directions are not clear.
The process as I understand it and what I have done:
Car w/o driver - Using gauge, I check and set the Camber and Caster with the car(and tire) on the ground. Make my adjustments, then check again. So in final, I have set both Camber and Caster desired settings with car/tire on ground and w/o driver.
Is this correct ot is there a better more acurate procedure?
My tire temps seem to be good across the tires doing this way.
Any advice?
Thanks, Roger