LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Brakes => Topic started by: rallyka on December 13, 2020, 01:53:02 am
-
Hi Guys
Newbie to Legends, I usually Rally here in UK but Covid is stopping that at the moment so have purchased a Legend to play at Hillcliming as I live very close to Shelshley Walsh course.
Looking to fit Wilwood calipers to rear of a legend as is to be a hill climb / track car in UK.
Appreciate over kill and will be dialed out with bias but want same caliper front and rear.
What Hawk bracket would do this or is there another way?
Thanks for any help
Andy
-
Hey Andy,
You will need to know the mounting hole spacing on the caliper (3 1/4" or 3 3/4") and the rotor diameter (10 1/4" or 10 5/8").
IE: If you have 3 1/4" mounting holes on the caliper and a 10 1/4 rotor the bracket number would be 31-325.
Hope that helps you.
Steve
-
Thanks Steve.
I was hopefully going to mount front standard disks on rear, then use the wilwood front caliper on rear also if possible as they are cheap enough. 3.75 centres 0.38 disk?
-
I am planning a similar swap for my SCCA car. I have not measured the rotor diameter yet. If 10 1/4" (with 3 3/4") use part number 31-375. If 10 5/8" rotor, use part number 31-385.
Steve
-
I should have a set of rear wilwood calipers and mounting brackets available after the first of the year. We are converting over a thunder roadster to the GTR version and upgrading the brake system with bigger four piston calipers.
Disc brakes are standard issue on the rear of the thunder roadster.
Randy - RPM
-
Hi Randy
That is the set up I need. Im in UK otherwise would buy that from you. Is there a part number for the bracket and also what disks size type would fit?
Thanks for all the help.
Andy
-
Andy,
Randy is a dealer out of California (USA). I think he would ship to you. Send him a message. Great guy to deal with!
Steve
-
Thanks Steve
Ive Pmd him