LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Engine Care & Tuning => Topic started by: mholewinski on July 23, 2016, 07:41:02 pm
-
As of now I have no spark and I was wondering what the resistance is on the INEX red coils. I am getting right around 3.5 Ohms on the primary side and 14,500 on the secondary. I have just under (like 11.43V) 12 volts going to the coils. Battery is at 12.3V. I have a good ground as well. Also, what kind of resistance should I be getting on the plug wires? I am running 16 AWG wire to the coils from the ignition box. Should these be of a smaller gauge so as to create more resistance to the coils? As always, any help is most greatly appreciated!!!!! Thanks!
-
Perhaps Dennis or Randy can help with your question. Guys; Any help?
Steve
-
The coils are a 3 ohm coil.o, 3.5 is within the specs.
99.9% of the time it is the box itself. Sent it back to Dyna and they repair them.
Is the red light flashing on the box when cranking?
Randy - RPM
-
Yup it is. Is that good or bad? Do you have any contact info for Dyna? Thanks! ~Mike
-
Never mind. I found their contact. ;D