LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Setup and Handling => Topic started by: CP Motorsport UK on April 23, 2010, 03:24:04 pm
-
Anyone help, I have lost all memory on these cars (9 years since I last raced them) and how to get a car to handle better by altering tire pressures. I have cut tires on the car, and set up helps car run round on rails, but I seem to be getting the back end too loose on exit of corners, compared to rest of drivers. It doesn't happen in all races, only when track temperature is up.
We measure tire temps over inside, middle and outside so can work out which tires are not working/working too hard, but can't remember what I need to do to change things?
Can anyone shed some light on this for me. We run asphalt (mainly tight 1/4 mile ovals).
Thanks
Chris
-
There is an old thread somewhere but can't remember where right off.
Can someone refresh us on this?
Steve
-
Loose In Loose Out Tight In Tight Out
Soften LF Spring Stiffen LR Spring Stiffen LF Spring Soften LR Spring
Stiffen RF Spring Soften RR Spring Soften RF Spring Stiffen RR Spring
Increase RF Air Pressure Decrease RR Air Pressure Decrease RF Air Pressure Increase RR Air Pressure
Decrease LF Air Pressure Increase LR Air Pressure Increase LF Air Pressure Decrease LR Air Pressure
Increase Pinion Increase Pinion Decrease Pinion Decrease Pinion
Try this. This is a general guide from Kevs Corner.
Steve