LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Brakes => Topic started by: IraceLegends77 on December 08, 2013, 07:06:53 pm
-
Does anyone know where you can find the installation directions for the new brakes? Or a picture. Thanks
-
Scott,
I will send you an electronic copy of Wilwood install directions tomorrow from work... :)
Mark
-
Mark,
Would you send me a copy also. I would like to add that to my files.
Thanks!
Steve
justfreaky@3riversdbs.net
-
Thanks for the help
-
They are supposed to come in the box with the kit.
The kits I sold from USLC all had directions in them
-
I bought a used set with extra pads. It didn't have the directions with it. It is crazy how much lighter they are.
-
Mine came with no instructions in box either as received from dealer. Instructions as attached.... ;D
-
Thank You Mark!
Steve
-
Thanks a lot Mark.
-
You are both very welcome! That's why we are all here - to help each other. ;D
-
Sorry for re-opening an old thread. Does anyone know where I can get more of the thin spacers? My brakes came with 7 thin ones and 4 thick. Anyway, it took 6 thin ones (3 per bolt) for the one caliper and I need a few more. :-\
While I'm at it, I assume the 90 degree fitting will go where bottom, inside, fitting is? The instructions say to clock the fitting towards the top of the car, which makes no sense.
Thanks in advance!
Adam
-
While I'm at it, I assume the 90 degree fitting will go where bottom, inside, fitting is? The instructions say to clock the fitting towards the top of the car, which makes no sense.
Pull the sticker off the side of the caliper, that's where the fitting goes.
-
I got some of the shims from Grainer.... But make sure you tell them you dont need the kitchen sink!!! I think they were like $12 for a bag full..
-
I used stainless steel washers. Worked like a champ.
-
There is a kit of different sizes. I got one from Mike at CMG. Don't remember the cost
Robert
-
Thanks all! And Duh... On the sticker. What a maroon...
-
Can someone post pics. The directions don't make since to me. Course I am new to legends, but I don't see how you can get to the caliper bolts with the rotor on.
-
You have to remove the rotor and hub to install that bracket.