LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Setup and Handling => Topic started by: jnally35 on May 12, 2016, 09:59:47 am
-
So I am trying to square my rear end and I want to set my offset but the frame right under my axle housing on the left side is bent in so I cant get a true measurement to make sure I am legal. Is there a way to make sure I am within the 6" minimum on the left side.
-
Replace the rear clip.
You might be able to use a straight edge at points that are straight and string (or measure) out from those points. That is assuming you have ant straight points to measure from.
Steve