LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Lubrication => Topic started by: racerdad on April 14, 2011, 08:11:05 pm
-
i just picket up a oil cooler off of ebay it was one of those from a top notch nascar team. it is a setrab 18 row 11" x 5 3/4 x 2" . the in and out an fittings are on one side and on the top and bottom. this will work for my daughters car right? will this be the big or the small cooler of the 2 coolers i will run? when i go looking for the oil cooler what size should i look for? one other question how do you know if it is a duel or single pass by looking at it? thanks for all the help cody
-
Sounds like a Setrab 619. One port on the top and one on the bottom usually indicates it is a dual pass, but the ports are also usually on opposite ends of the cooler for a dual pass, so I can't say for sure, but think it's probably a dual pass.
I only run one cooler (Setrab 920), but I would assume by the size that that would be the bigger of the two.
-
so i got my oil cooler today and the cooler was used for a rear end cooler. is there a differance between a oil cooler and a rear end cooler? also it does not say setrab on the cooler but the mail an fittings do say setrab.should it say the name or do they not stamp it on the cooler? if it is OK to use how should i flush the cooler out?
thanks cody