LegendsRacer - Legends & Bandolero Racing Forum
LEGENDS => Engine Care & Tuning => Topic started by: igotmylegend on July 02, 2011, 08:56:07 am
-
Are they reusable? Before I get into them I would like to make sure.
Thanks
-
Vince,
I have resused the carburetor bowl gaskets on both sets of my carbs with no issues. Just like any other gasket, a little care goes a long way. If they tear for some reason, well then it's time for new ones.
BTW - Hand tighten fasteners only. I purchased some short(I believe 5 mm thread x 10 mm long) stainless steel socket head bolts from my local fastenal store to replace the original phillips drive bolts. Much nicer and easier to work with when changing jets.
Good luck! ;)
-
Thats what I was woundering, I guess I'll buy me a set just in case.
Thanks
-
I've never had to replace a carb bowl gasket on my carb sets or other racers that I have gone through their carbs, in over 10 years. Once the bowl screws are removed, I lightly thump the side of the bowl with a small plastic mallet to break the bowl loose from the gasket
~ Gimp ~