« previous next »
Pages: [1]   Go Down

Author Topic: Shifter Linkage  (Read 5472 times)

Offline Gunnar1778

  • Newbie
  • *
  • Posts: 2
Shifter Linkage
« on: February 17, 2021, 10:31:27 am »
I broke my shifter linkage a few months ago and finally got to putting it back together. Does the final piece of the linkage that connects to the spline connect at an angle or should it be straight up or down? It seems to be binding up when I connect it and try to shift.
Logged


Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4513
Re: Shifter Linkage
« Reply #1 on: February 17, 2021, 01:52:11 pm »
Splined linkage should be at a little angle.
Might have to slide it off and move a little to get it right.

Steve
Logged
Better to be hated for who you are, Than to be loved for who you are not.

Offline Gunnar1778

  • Newbie
  • *
  • Posts: 2
Re: Shifter Linkage
« Reply #2 on: February 17, 2021, 07:36:24 pm »
Would you be able to send a picture of what it should look like for reference?
Logged

Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4513
Re: Shifter Linkage
« Reply #3 on: February 17, 2021, 08:06:47 pm »
Unfortunately, I don't have a good pic for you. Try moving the lever (splined part) 1 spline either way and see if it is better or worse. If worse; Move 2 splines the other direction. Once you are fairly close; Use the heims to dial it in.

Steve
Logged
Better to be hated for who you are, Than to be loved for who you are not.
Pages: [1]   Go Up
« previous next »
 

anything