LEGENDS > Brakes

Rear Wilwood Calipers /

(1/2) > >>

rallyka:
Hi Guys
Newbie to Legends, I usually Rally here in UK but Covid is stopping that at the moment so have purchased a Legend to play at Hillcliming as I live very close to Shelshley Walsh course.
Looking to fit Wilwood calipers to rear of a legend as is to be a hill climb / track car in UK.
Appreciate over kill and will be dialed out with bias but want same caliper front and rear.
What Hawk bracket would do this or is there another way?
Thanks for any help
Andy

justfreaky:
Hey Andy,

You will need to know the mounting hole spacing on the caliper (3 1/4" or 3 3/4") and the rotor diameter (10 1/4" or 10 5/8").
IE: If you have  3 1/4" mounting holes on the caliper and a 10 1/4 rotor the bracket number would be 31-325.
Hope that helps you.

Steve

rallyka:
Thanks Steve.
I was hopefully going to mount front standard disks on rear, then use the wilwood front caliper on rear also if possible as they are cheap enough. 3.75 centres 0.38 disk?

justfreaky:
I am planning a similar swap for my SCCA car. I have not measured the rotor diameter yet. If 10 1/4" (with 3 3/4") use part number 31-375. If 10 5/8" rotor, use part number 31-385.

Steve

RPM:
I should have a set of rear wilwood calipers and mounting brackets available after the first of the year. We are converting over a thunder roadster to the GTR version and upgrading the brake system with bigger four piston calipers.

Disc brakes are standard issue on the rear of the thunder roadster.




Randy - RPM

Navigation

[0] Message Index

[#] Next page