Author Topic: Front End & Frame Alignment/Specs  (Read 734 times)

Offline barboni

  • Newbie
  • *
  • Posts: 1
Front End & Frame Alignment/Specs
« on: September 08, 2019, 10:42:46 pm »
We had a pretty good wreck last weekend and tore off the right front spindle/wheel. Looking to put the car back to correct alignment but wasn?t sure if the frame was tweaked or what exactly that should look like. I believe we have all the correct tooling as we have tram bars and caster/camber tools but does anyone know what spec looks like. Hoping for some sort of document illustrating measurement points for frame and an alignment procedure. Thank you in advance!

Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4319
Re: Front End & Frame Alignment/Specs
« Reply #1 on: September 10, 2019, 07:29:41 pm »
Check the rule book on page 101; There are a lot of measurements for the frame on that page.

Better to be hated for who you are, Than to be loved for who you are not.