LEGENDS > Setup and Handling

Front End & Frame Alignment/Specs

(1/1)

barboni:
We had a pretty good wreck last weekend and tore off the right front spindle/wheel. Looking to put the car back to correct alignment but wasn?t sure if the frame was tweaked or what exactly that should look like. I believe we have all the correct tooling as we have tram bars and caster/camber tools but does anyone know what spec looks like. Hoping for some sort of document illustrating measurement points for frame and an alignment procedure. Thank you in advance!

justfreaky:
Check the rule book on page 101; There are a lot of measurements for the frame on that page.

Steve

Navigation

[0] Message Index