« previous next »
Pages: [1]   Go Down

Author Topic: size of tap for rear end housing  (Read 4232 times)

Offline smokinjoe00

  • Newbie
  • *
  • Posts: 35
size of tap for rear end housing
« on: June 03, 2018, 10:06:22 am »
anyone know what size of tap the housing studs are? have a couple bad threads on my housing want too clean up thanks
Logged


Offline Legends57x

  • Sr. Member
  • ****
  • Posts: 414
Re: size of tap for rear end housing
« Reply #1 on: June 03, 2018, 02:58:54 pm »
If I remember correctly, studs used to retain rear end gears are all Metric, M8 x 1.0. I assume you are looking to use a die to clean up or chase the threads. Good luck!
Logged
Mark Ritger
INEX Legends #1x

Offline smokinjoe00

  • Newbie
  • *
  • Posts: 35
Re: size of tap for rear end housing
« Reply #2 on: June 03, 2018, 03:15:06 pm »
yes I am thanks
Logged

Offline Prov1

  • Newbie
  • *
  • Posts: 1
Re: size of tap for rear end housing
« Reply #3 on: August 04, 2021, 04:34:16 pm »
I have a bad stud in my pumpkin, just wondering if it is M8x1.0 or M8x1.25

Thanks
Logged

Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4495
Re: size of tap for rear end housing
« Reply #4 on: August 06, 2021, 01:46:02 pm »
I believe it is M8 x 1.0

Steve
Logged
Better to be hated for who you are, Than to be loved for who you are not.
Pages: [1]   Go Up
« previous next »
 

anything