LEGENDS > Drivetrain & Gearing

size of tap for rear end housing

(1/1)

smokinjoe00:
anyone know what size of tap the housing studs are? have a couple bad threads on my housing want too clean up thanks

Legends57x:
If I remember correctly, studs used to retain rear end gears are all Metric, M8 x 1.0. I assume you are looking to use a die to clean up or chase the threads. Good luck!

smokinjoe00:
yes I am thanks

Prov1:
I have a bad stud in my pumpkin, just wondering if it is M8x1.0 or M8x1.25

Thanks

justfreaky:
I believe it is M8 x 1.0

Steve

Navigation

[0] Message Index