LEGENDS > Drivetrain & Gearing
size of tap for rear end housing
(1/1)
smokinjoe00:
anyone know what size of tap the housing studs are? have a couple bad threads on my housing want too clean up thanks
Legends57x:
If I remember correctly, studs used to retain rear end gears are all Metric, M8 x 1.0. I assume you are looking to use a die to clean up or chase the threads. Good luck!
smokinjoe00:
yes I am thanks
Prov1:
I have a bad stud in my pumpkin, just wondering if it is M8x1.0 or M8x1.25
Thanks
justfreaky:
I believe it is M8 x 1.0
Steve
Navigation
[0] Message Index
Go to full version