LEGENDS > Drivetrain & Gearing

Changing 3rd member tonight.

(1/2) > >>

ZForceRacing01:
Tonight I am swapping my complete Third member from 3.33 to 3.42.

I know to drain fluid and pull the axels out of the center section. Then remove and replace third member.

I can't seem to find a youtube video explaining the axel pull process on any vehicle let alone a Toyota.

Any incite is appreciated. 

justfreaky:
That is pretty much it.
Undo the retaining bolts and pull the axles out. Be sure to check them for twist while you have them out. New seals? Is a good time to put them in.

Steve

slack11:
Turn your brake drum backwards, and reinstall on the axle, it'll give you something to grab onto to pull in order to "pop" the axle out.  Also makes a nice little stand to let the axles stand on while you have it all apart.

s10custom:
Never thought of that, great idea

Winterracing:
I always used an axle puller, I know everyone will say "you shouldn't need one if your rear end is straight and everything" but they were quick to attach and took 2 seconds to get the axle out versus putting the brake drum on and doing it that way.  Just my opinion though.

Dan

Navigation

[0] Message Index

[#] Next page