LEGENDS > Drivetrain & Gearing
Changing 3rd member tonight.
ZForceRacing01:
Tonight I am swapping my complete Third member from 3.33 to 3.42.
I know to drain fluid and pull the axels out of the center section. Then remove and replace third member.
I can't seem to find a youtube video explaining the axel pull process on any vehicle let alone a Toyota.
Any incite is appreciated.
justfreaky:
That is pretty much it.
Undo the retaining bolts and pull the axles out. Be sure to check them for twist while you have them out. New seals? Is a good time to put them in.
Steve
slack11:
Turn your brake drum backwards, and reinstall on the axle, it'll give you something to grab onto to pull in order to "pop" the axle out. Also makes a nice little stand to let the axles stand on while you have it all apart.
s10custom:
Never thought of that, great idea
Winterracing:
I always used an axle puller, I know everyone will say "you shouldn't need one if your rear end is straight and everything" but they were quick to attach and took 2 seconds to get the axle out versus putting the brake drum on and doing it that way. Just my opinion though.
Dan
Navigation
[0] Message Index
[#] Next page
Go to full version