I have heard some different opinions of where the oil level should be. I did my first oil change on my car for my first race in coming up the end of the month. No sure what the exact capacity for my cooler set up, so I started with 3 qts. I spun the motor over for 2-3 seconds, stop and did so I again. Hoping this would prime the oil lines. Then I started and let it run for 3-5 minutes. I would have let in run longer but didn’t want to let it run too long when I knew it was low on oil.
Sight Glass
Cold I was 1/2 full, hot the oil was not visible.
I added 1/4 qt, and let it sit to get cold and I will repeat in the morning.
If I remember correctly the goal should be. 3/4 full cold and 1/4 visible hot in the sight glass.
Haven’t been able to get ahold of the US Legend engine shop as of late to get a recommendation.