LEGENDS > Brakes

braided brake lines

(1/2) > >>

cr125:
Hello , I am trying to replace my rigid brake lines with braided lines and I have two questions. What fitting to use out of a 2 port aluminum master cylinder (10mm)? and what size AN fitting to use 3 or 4? Thank you

canabl:
most master have 1/8 bsp fittings, much same as the wilwood brake bias etc. I have always stuck with 3AN hoses so i could utilise sprintcar, speedcar hose kits. lightweight kevlar was in my old car and new modlite runs the nylon hose with crimp fittings.

cr125:
Thanks for your help, i was thinking that i would have to use a metric thread on the master cylinder  and wanted to order new lines.

knoxracing:
I know some will argue, I am not a fan of the braided lines throughout the car. Too much flex and movement.

VMS Motorsports:

--- Quote from: knoxracing on March 11, 2015, 10:08:21 am ---I know some will argue, I am not a fan of the braided lines throughout the car. Too much flex and movement.


--- End quote ---

+1

Navigation

[0] Message Index

[#] Next page