Looking for set-up help on 3/8 mile banked track

[knoxracing]

Ozzie'
Your total ball joint width is 32 1/8th plus.  with your camber settings, the total width should be illegal. What tracks are you racing? Just trying to figure your set up out, thanks!

[Richie25x]

Ozzie'
Your total ball joint width is 32 1/8th plus.  with your camber settings, the total width should be illegal. What tracks are you racing? Just trying to figure your set up out, thanks!

Was wondering the same.  i think he meant 16 3/16th on the right.
Also why run a 1/2 spacer on the LF if you are going to run max wheelbase at 73 1/4
It would be better to run a 1/4 spacer on LF and have it parallel with RF and you would get wheel base at 73 1/8 LS.
When i run a 1/2 on the LF lower it is to make LS shorter 72 7/8.

[ozzie]

I'm pretty sure the LF was 14 7/8. The RF could be 17 1/16 to 17 1/8. I think the total was 32 inches. LF camber is 3.18 and RF is 5.87. Fit through hoop. The rear end I got from US Legends barely fit through the hoop. When I measure toe with plates, the measurement is approximately 59 3/8.