« previous next »
Pages: 1 [2]   Go Down

Author Topic: Steering column support...  (Read 18992 times)

Offline slack11

  • Sr. Member
  • ****
  • Posts: 261
Re: Steering column support...
« Reply #15 on: February 27, 2013, 06:29:36 pm »
I called on that piece... It isn't INEX legal.   Has needle bearings in the tube.    It is a nice piece though...
Logged

Offline legendsracer95

  • Newbie
  • *
  • Posts: 24
Re: Steering column support...
« Reply #16 on: February 27, 2013, 09:14:02 pm »
Quote from: racerdad on February 27, 2013, 05:05:28 pm
I think what you are talking about is here
http://www.andrewsmotorsports.com/images/fabshop/shaft_2.jpg
Does any one know if this is ok to use.
Thanks cody

Hey Cody, where did you find this?
Logged

Offline legendsracer95

  • Newbie
  • *
  • Posts: 24
Re: Steering column support...
« Reply #17 on: February 27, 2013, 09:25:07 pm »
Never mind,found it!
Logged

Offline Richie25x

  • Jr. Member
  • **
  • Posts: 72
Re: Steering column support...
« Reply #18 on: February 28, 2013, 04:37:20 pm »
Quote from: slack11 on February 27, 2013, 06:29:36 pm
I called on that piece... It isn't INEX legal.   Has needle bearings in the tube.    It is a nice piece though...

If the bearing was replaced with bushings would it be legal?
Logged

knoxracing

  • Guest
Re: Steering column support...
« Reply #19 on: February 28, 2013, 09:51:29 pm »
I woud say if it had the stock bushings it would be legal.
Logged
Pages: 1 [2]   Go Up
« previous next »
 

anything